Hang chargers off the ground, visible, and with easy access for charging.
Find a place for Transmitters to charge with provided power strip.
IGNORE ALERT "The connected charger will take longer to charge. To charge faster, use the original charger and cable..."
**If you cannot locate the course file by name and/or city, reach out to your Club Car representative or search for the course at https://skydroid.net/courses.php. If it is not preloaded, Club Car will need to map the course, which may take a couple days. When this is finished follow these instructions on how to download a file via WiFi.**
WiFi Download Method
Within the Tempo Walk App
Training, Training, Training!!!
Status
Situation
Steps to Fix
Tools Required
Normal: Tempo Walk powers on, but won’t charge.
Charger not plugged in right.
Plug in normal charger (make sure to align tabs) and wait for progress % lights. If charger adapter is forced in the wrong way, the inline fuse can blow on the TW charger cable. Tilt the TW up and pull the fuse holder out to examine 10A fuse. This is located 12” from plug end, inside the TW frame area.
None
Stage 1: Battery % lights don’t work.
Battery went into protection mode.
Press circuit breaker button only and then replug the normal charger and wait for progress % lights. Only close the circuit breaker arm after the TW is charging properly.
Stage 2: Battery % lights still don’t work.
Stage 1 charging doesn’t work.
Leave circuit breaker open and charger plugged. Next, hold the mode button until 13.6V repair mode shows, they press it again until 12V repair is selected. Leave trickle charging overnight and try 24V normal mode after to see if it charges.
Stage 3: TW battery voltage below PCM threshold
Stage 2 charging doesn’t work.
Leave circuit breaker open and then plug in jumper cable to trickle charge (5-30 min). Then plug in the normal charger and wait for progress % lights.
Jumper Cable
Stage 4: TW battery voltage way below PCM threshold.
Stage 3 charging doesn’t work.
Leave circuit breaker open, remove top plastic (careful with all wires). Next attach the jumper cable with alligator clips to battery terminals. Finally, plug in the normal charger and wait for progress % lights.
Jumper Cable w/ alligator clips, and 7/16 hex nut with drill
Stage 5: TW battery is unresponsive.
Stage 4 charging doesn’t work.
Watch training videos on how to replace the battery.
7/16 hex nut with drill, and new battery